Match the Guard to Your Trees
The right guard depends less on the brand than on what falls on your roof.
Maples: leaves and helicopter seeds
Maple leaves are large and easy to block, but the spring drop of helicopter seeds is not. Seeds slip through screens with large openings, pack into the gutter and sprout. A mesh guard fine enough to stop seeds is the minimum for maple-heavy lots.
Oaks: tassels, acorns and late leaves
Oaks shed stringy flower tassels in spring, acorns in late summer and leaves late into fall, sometimes after the first snow. Tassels mat on coarse screens and block water from getting in. A fine, rigid mesh that sheds debris off the surface works best.
Pines, spruce and other evergreens: needles
Needles are the hardest debris for a gutter guard. They slide into anything but the finest openings and stand upright in coarse screens, where they catch more debris. Homes under evergreens need the finest mesh available.
Mixed trees and shingle grit
Most Central Michigan lots have a mix of trees, plus fine shingle granules washing off the roof. When debris is mixed, choose the guard for the smallest thing falling on your roof, not the largest.
EPHI Gutter Guard Options: EP FlowGuard™ to EP UltraGuard™
EPHI offers four levels of gutter protection, so the guard can be matched to the trees on your property:
- EP FlowGuard™ (Good): an entry-level guard for homes with broadleaf trees and moderate debris
- EP StormGuard™ (Better): a durable all-aluminum guard for heavier leaf loads
- EP MaxGuard™ (Best): fine 14-mesh micro-mesh that stops leaves, maple seeds and oak tassels
- EP UltraGuard™ (Premier): our finest 30-mesh micro-mesh, for pine needles, small seeds and shingle grit
On new gutters, guards install with your EP FlowSeries™ seamless system. On existing gutters, we check the slope, hangers and downspouts first, because a guard can’t fix a gutter that already overflows (see why gutters overflow). Compare all four options on our gutter guard page.
What Gutter Guards Can’t Do
Guards greatly reduce gutter cleaning, but no guard is maintenance-free:
- Debris on top. Leaves and needles can collect on the guard surface. Most dry and blow off; heavy, wet buildup should be cleared from the surface.
- Fine films. Pollen and tree sap can leave a film on fine mesh that slows water entry over time; an occasional rinse restores flow.
- Ice dams. No gutter guard prevents ice dams. Ice at the eaves comes from heat escaping into the attic, and the fix is attic insulation and ventilation (home insulation services).
- Poor gutters. A guard won’t correct bad slope, sagging or undersized downspouts.
We’re upfront about these limits. For more, see common gutter guard myths.
Gutter Guards on Tree-Heavy Lots in Central Michigan
Central Michigan’s mix of hardwoods and evergreens means debris falls from spring through late fall: maple seeds in May, oak tassels in early summer, leaves from September into November, and needles year-round. Freeze-thaw cycles make clogged gutters worse, because trapped debris holds water that freezes and loosens hangers. EPHI installs gutter guards across Central and Mid-Michigan, including Mt. Pleasant and Alma.
How to Choose and What Happens Next
- Note which trees overhang your roof and when they drop the most.
- Check whether your gutters overflow even when clean. If so, fix the gutters first.
- Get pricing on any EP gutter guard level with EP SmartQuote+™, or schedule a free estimate and we’ll recommend a level for your trees.
All EPHI installation workmanship is covered by the EP Protection Plan™ for as long as you own the home. Call (989) 833-1000 with questions.